Product Information:
Material: Aluminum Alloy, Iron
Quantity: 1 PC
Color: Black
Package: 1 H Connector, 1 T Connector, 1 Rectangular Connector, 2 Long Bolts, 2 Short Bolts, 2 Nuts, 3 Gaskets, 1 Ring
Size: H Connector: 3.14×1.18 inches T Connector: 3.14×2.36 inches Rectangular Connector: 3.18×0.86 inches Long Bolt: 2.91×0.31 inches Short Bolt: 1.77×0.31 inches Nut Diameter: 0.27 inches Gasket Diameter: 0.63 inches
Weight: 0.85 lb
Specific installation steps:
-First, remove the valve cover, and then remove the rocker arm and rocker arm guide.
-Next, place the bottom plate and middle section where the rocker arm bolts are installed on top of the studs with 2 bolts in the head, making sure the tool is set between the two valve springs.
-Tighten with a wrench and a socket.
-Make sure the studs are greased, place the top on the two valve springs, and install the nuts.
-If you are using this head on an engine mounted head, and then you want to use a fitting for compressed air in the spark plug hole to keep the valve pushed in close before tightening.
-Tighten nuts slowly.
-To prevent them from falling into the head, you can remove the valve retainer with a magnet after compressing the spring.
-After removing the retainer, you need to slowly twist the nut to release the pressure and remove the spring.
Product advantages:
-It is compact for easy storage in the tool case.
-Surface is carefully polished without rough particles, so that this product will not wear machines.
-Car valve spring compressor tool kit has higher strength, dust resistance, which ensures reliable and long-lasting durability.
-In spite of the large number of tools in this kit, the including tools are small and lightweight, easy for you to grab, carry, and store.
Warm tips:
-Be sure to maintain air pressure in the cylinder when replacing the spring.
-Do not impact, because it will cause the nut to overheat and strip the threads.