Specification:
Condition:100% Brand New
Colour: Black, Yellow
Material: Plastic & Aluminium
DC 12V,60W,5A
Motor Oil (40-60 degrees) Flow Rate: approx. 1L / min
Diesel Flow Rate: approx. 250L / Hour
Inlet Hose Length: approx. 155cm/61'',Outer Diameter: 6mm/0.236'' ,Inner Diameter: 4mm/0.157''
Outlet Hose Length: approx. 124.5cm/49'',Outer diameter: 12mm/0.472'',Inner Diameter: 10mm/0.39''
Line Length: approx. 71cm/28''
Package Weight: approx. 1070g
Easy Operation:
Warm up the engine for about 5 minutes to reduce the oil viscosity. It's important that the engine oil is warm (not hot) when extracting.
Turn off the engine and loosen the filler cap (for the time being)
Connect the power clip of the pump body directly to the battery
Remove the oil level gauge and insert the thin hose of the pump. (Notice if you put it to the innermost very quickly,it won't work)
Gradually insert the hose while operating the pump.
When it is inserted to some extent,the operating noise will change and the oil will start to be sucked up.
Put the thick discharge hose on the waste oil tray. (If you put it directly in the waste oil treatment box, you will not know the amount of waste oil collected.)
Warm Tipps:
We recommend a short break after 10 minutes continuous usage (should not exceed 30 minutes) to allow the unit to cool.
Clean this pump after use, you can flush with washing detergent and then run with fresh transmission oil to run out water/detergent.