-Conditon: 100% Brand New High Quality

-Material:ABS plastic + PC
-High quality,Long-lasting,Super bright
-Simple to fit the tail,brake,and turning sighals (left & right) are all integrated in one.
-Available color for lens:Smoke/Clear/Red
-Light color:Red/Yellow
-Driving light power: 12V/0.36W
-Brake light power: 12V/1.8W
-Turn signal power: 12V/1.08W
-Easy to install;Without instructions.
-If the light work abnormaly,you need to add a resistance.

Wiring Diagram applicable to most bikes:

Black Wire(Negative),
Green Wire(Brake)
Red Wire(Running Light)
1. Connect one end of the resistor to the ground wire on your turn signal harness from your bike.
2. Connect the other end of the resistor to both the YELLOW wire from our taillight and the positive
turn signal wire from your turn signal harness from your bike.
3. Repeat the same process for the other side.
To use the red connectors, place one wire inside along one channel, place another wire inside along
the other channel. Push down the metal pin as it will make a small cut on each wire bridging the connectors.

if you are using the resistors, place one end of the resistor in the middle of either channel along with the one wire.