Noiseless Good Balance,4 Conduct with shield,About 102mm in length, 49mm in width, and 20mm in height
The black and ground that are together are the ground. The two hooked together tape up don't use. The single other wire is your hot . That's 2 wire hook up. You could hook a switch from the 2 not used and to the hot and your pick ups would be single coil or humbucking. There are many wiring options by using these 2 to put pickups in and out of phase
The conductor wires are red for hot, black for neutral with a white and green soldered together joining the coils
each coil have separate wires to connect to separate volume knobs. It is 2 coils with 4 wires.
Can't this be connected as an active pickup, it's possible to use it with an active preamp.is a passive pickup.It can be used without a preamplifier. To ensure that the pickup does not work in the case of proper connection, check to see if there is any damage inside it. Use a multimeter to measure the resistance. The normal resistance is around 12k ohms.
it comes with about 1/4" exposed wire to solder your connections
