*** Please note ***

This "Large Foot Controller" cannot be used with the "Remote Thread Cutter" if your machine does not have two pin jacks. There are two types of "large foot controllers": one with a pin jack on the left side and one without a pin jack. This controller is the type without a pin jack, so the "remote thread cutter" cannot be used with it.
If you wish to use this controller with the "Remote Yarn Cutter," please purchase the "Large Foot Controller" with a pin jack. Please note this point.

However, if your sewing machine is equipped with two pin jacks, you can use it with the "Remote Thread Cutter". In that case you can use this "Large Foot Controller" with the "Remote Thread Cutter". If your sewing machine has only one pin jack, you can use the "Large Foot Controller" with your machine, but not the "Remote Thread Cutter". Please be careful.

This foot controller fits in with a sewing machine of a computer.

-The main model with which I fit in is the following.-
Memory Craft : 12000, 11000(SE), 8900QCP, 9900,
77007700QCP, 8100, 6600, 6500, 4000, etc.
DC4030, DC2007, DC1018, DC1050, DC5100, DC2014,
DC2013, DC2012, DC2011, 7330, 3160QCP Skyliine-S5, ..etc

(*However, as mentioned above, if you want to use it with the "Remote Thread Cutter", your sewing machine must have two pin jacks.)

When it's unclear, please question anytime!