Feature:
1. Single channel USB to serial / parallel with a variety of configurations.
2. Whole USB protocol handled on the chip, no USB specific firmware programming required.
3. USB 2.0 high-speed (480Mbits/Second) and full speed (12Mbits/Second) compatible.
4. Multi-protocol synchronous serial engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, (MASTER) or bit-bang) design.
5. UART data transfer rate up to 12Mbaud (RS232 data rate is limited by external level shifter).
6. USB to synchronous 245 parallel mode transfer up to 40 megabytes/second.
7. USB to asynchronous 245 mode data transfer rate up to 8 megabytes per second.
8. Support for special half-duplex FT1248 interface with configurable width, bidirectional data bus (1, 2, 4 or 8 bit wide).
9. CPU - style interface mode simplifies CPU interface design.
10. Fast serial interface option.
11. FTDI's royalty- Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
12. Adjustable receive buffer timeout.

Spec:
Condition: 100% Brand New
Item Type: USB to JTAG UART/ SPI/I2C Module
Typical Applications
Single chip USB to UART (RS232, RS422 or RS485)
USB to
USB to FT1248
USB to JTAG
USB to SPI
USB to I2C
USB to Bit-Bang
USB to Fast Serial Interface
USB to CPU target interface (as memory)

Package List:
1 x Module
3 x Pin Header