The Best Key Fob Replacement
An inexpensive replacement for your original remote key fob, the car key replacement is
self-programmable and comes with easy do-it-yourself instructions to help you program
your new car key at home.
100% Brand new 3 button Remote key fob installed batteries,electronics,transponder chip

Compatible With Ford:
2003--2011 e150 e250 e350
2007-2014 edge
2001-2014 escape
2000-2003 escort
2000-2005 excursion
1998-2014 expedition
1998-2014 explorer
2001-2010 Explorer Sport Trac
1998-2014 F150 F250 F350
2004-2007 freestyle
1998-2011 ranger
1998-2003 windstar

Compatible With Lincoln:
2006-2008 mark lt
1998-2003 navigator

Compatible With Mazda:
1999-2009 B2300 B2500 B3000 B4000
2001-2011 Tribute

Compatible With Mercury:

2005-2011 mariner
2004-2007 monterey
【How to program】
Option 1:
1.Close all doors, then open driver's door and press the Unlock button on driver's door while it is open and insert key into the ignition.
2.Turn ignition from OFF to RUN 8 times within 8 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming
mode. (if the door locks do not cycle, then it was done incorrectly. You must start over by removing key and beginning from step 1)
(Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
3. Within 10 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you
only have one remote then skip to step 5.
4. Within 10 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 4 for
all other remotes.
5. Turn ignition to OFF. Locks will again cycle to indicate the end of programming mode.
*If this does not work try the procedure with the door closed.

Option B:
1. Fasten seatbelt and close all doors.
2. Turn the ignition from OFF to RUN 4 times within 3 seconds.
3. Turn the ignition OFF. The system will chime to confirm programming mode.
4. Within 10 seconds, press and hold any button on the first keyless remote. The system will chime once to confirm programming.
5. Within 10 seconds, press and hold any button on the second keyless remote. The system will chime once to confirm programming.
6. Turn ignition to RUN to exit programming mode.

Please note: All steps should be performed in rapid succession. If you do not hear the initial chime or door lock cycle, this means the vehicle
never entered programming mode. You should remove the key from ignition, open and close the door and start over.