This is a 2 set kit, Each kit consists of a Micro Effects Dimmer Control (MED1) with 8 different dynamic lighting effects modes, a green silicone bi-pin LED lamp with 1.5 meter (5 foot) Typ. length cable socket assembly (EEL1-1.5M-SBL2-G), and a 12 volt battery holder (BHC1-8AA-12V). This unit is a professional LED green light source used for building props and scenery. The green LED lamp operates from 12 volts DC at 140ma nominal current (1.7 watts) with light output of 130 lumens. The kit is operated from 8 AA batteries, and runs for more than 10 hours on new alkaline batteries (not included). The cable socket assembly can be press fit into a 7/16” hole drilled into rigid foam, wood or other material. The taper of the socket body locks it into place, and the socket has a front flange to limit the insertion depth and provide a finished appearance. The MED1 (Micro Effects Dimmer, control) functions are as follows: The Light button is used in static mode for dimming. The Speed (On/Off) button provides ten speed levels for the effects modes and is also used to turn the unit off when it is held longer than 3 seconds. The Mode button provides eight dynamic effects, and the Static (0 mode). Lighting Effects are: 0) Static mode for dimming 1) Up Down – ramp up on ramp down off – repeat. 2) Up Down – flame flicker – always on. 3) Strobe – fast. 4) Blinking – long off. 5) Blinking – long on. 6) Flash - burst of pulses 7) Strobe – slow 8) Up Down varying brightness – brief off – repeat. Applications: Special effects props Escape Room lighting and props Theatrical stage scenery and props. green lights for theming applications.