Search

Search

-25%

FYSETC Prusa i3 MK4 XL Replacement Original Thermistor - Hot End Heater block Part - 3D Printer Accessories: 104NT 100K High Temperature Sensor +300 Degrees 2Pin with M3 Grub Screw for MK3.9 Nextruder

KWD 5
Brand
FYSETC
Weight
18 g
– 1 +

Special Features

  • 1. Drop in replacement 3D printing project: replace the stock Nextruder heaterblock temp sensors, only compatible with newest prusa MK4 MK3.9, not compatible old version MK3S MK3 MK2.5S MK2.5 MK2S MMU2S CW1 SL1 MINI MK3S+ MINI+ SL1S CW1S MK2 MMU2 MMU1 XL MMU3. This version Thermistor Line Length about 90mm, Not for Original Prus XL which needs Length 115mm. We will upgrade it next batch.
  • 2. Spare part for the stock cartridge thermistor: 104NT sensor, the 104GT-2 thermistor's upgrade, newest model, 304 stainless steel cover the internal temperature package, about 90mm Wire, with 2pin MX connector, Temperature measurement head cylinder diameter 3mm, length 8mm, the total length is about 122mm/4.8inch,can be used with the same size like v6 heating block that support the thermocouple.
  • 3. Ease of use: it is a great replacement for a broken thermistor, locks onto the board connector. The Customized Terminal Connector is specially for MK4/MK3.9 prus loveboards, so please check before ordering.
  • 4. Great temperature match: The temperature measurement: -50 °C ~ +300 °C for a long lifecycle, sometimes can reach up to +300℃ for a short time using, can replace the v6 hot end K-type thermocouple temperature, very fit for printing high-temperature filament ABS ASA PETG. （Please note that the temperature should not be over 300 °C, otherwise the temperature will not be accurate.)
  • 5. For the MK4 Spare part, our shop also has 24V 40W heater cartridge 6X12mm - Hardened Nozzle ObXidian - Heatbed thermistor set - Heater block etc, if needed, please enter our shop or email us.

Description

Feature:
Great temperature match: The temperature measurement: -50 °C ~ +300 °C for a long lifecycle, sometimes can reach up to +300℃ for a short time using, can replace the v6 hot end K-type thermocouple temperature, very fit for printing high-temperature filament ABS ASA PETG. （Please note that the temperature should not be over 300 °C, otherwise the temperature will not be accurate.)
Temperature Sensor Head: 3x8mm, the total length is about 122mm/4.8inch. Marlin Firmware Configuration: * 5 : 100K thermistor - ATC Semitec 104GT-2/104NT-4-R025H42G (Used in ParCan & J-Head) (4.7k pullup); #define TEMP_SENSOR_0 5.

Related Items

{"error":"Error","cart_limit":"You have too many items in your cart.","prod_limit":"You cannot add any more of this item"}