Search

Search

3 PCS Cuttable Screen Protector for Resin 3D Printers (300 * 210mm)

KWD 9.500
Brand
TMYPN
Weight
101 g
Size3 * 300*210 Screen Protector
StyleSuit for Resin 3D Printers
– 1 +

Special Features

  • Compatible Models: 300*210mm Screen Protective Film compatible with most of Resin 3D Printers. Package included 3 * Screen Protective Films, 6 * Tool Kits, 6 pairs of stickers, 1 * Plastic Scraper.
  • Protective film can be cut to size you need, each grid spacing is 5mm, measure you screen size, and then cut it to the correct size. Note: The back side with the grid lines is the side attached to the screen face.
  • Screen Protector: Made of high-quality PET with 0.1mm thickness, with light transmittance of more than 95%, and will not affect the 405nm wavelength of ultraviolet rays through the protective film and curing the resin.
  • The screen protective film can not only protect the screen from being scratched but can also prevent resin leakage from contaminating the screen due to damage to the release film, thereby prolonging the use time of the screen.
  • This screen protector film kit includes tool kits to make it easier to install the screen protector, and the screen protective film will not affect the print volume after installation.(Installation method reference picture, If the shading tape around the screen is too large, you need to remove the shading tape and install the protective film, and then reattach the shading tape.)

Description

Compatible with Most of Resin 3D Printers

Specification:

- Materials: High-quality PET material

- Light Transmittance: More than 95%

- Thickness: 0.10mm

- Will not affect the 405nm wavelength of ultraviolet rays through the protective film and curing the resin.

Installation Steps:

- Step 1: Measure the size of the screen, cut the film to the corresponding size, and pay attention to the length of each grid line of 5mm..

- Step 2: The cut protective film is pasted with a small sticker, which is convenient to tear off the surface film when applying the film. The one with grid lines is the back of the film, which needs to be veneered on the screen..

- Step 3: Wipe the screen with a dry wipe.

- Step 4: Use a dust absorber to remove fine dust.

- Step 5: Peel off the back of the screen protector. Align the protector with the edge of the screen and stick it from one end to the other with a plastic scraper. Get the installation carefully without air bubbles. If the shading tape around the screen is too large, you need to remove the shading tape install the protective film, and then reattach the shading tape.

Related Items

{"error":"Error","cart_limit":"You have too many items in your cart.","prod_limit":"You cannot add any more of this item"}