All electronics ship with US style plugs.You may need a voltage converter or a plug adapter.
Special Features
-1.3 OLED use S H 11 06 chipset, not S S D 13 06, so you need to install U8g2 library. You will have artefacts issues with your display if use S S D 13 06 library.
-The actual default I2C address of OLED is 0x3C, not the 0x78 or 0x7A printed on the back. You must properly define this address in any sketch, or you will not get data sent to the display and may mistake it for being DOA.
-You need to change it's address if want to use 2 oled on the same u n o. On the back you will see a tiny section, a resistor (303 value which is 10k ohm) and 3 solder pads. To change it's address, you must lift this tiny SMD resistor and move it to the other pad with the right tools.
-There is a removable transparent film on each OLED glass surface for scratch resistant protection until use.
-Comes with 3x 1.3 oled display i2c with 4 pin headers already soldered on, so no soldering required.
DIYmalls 915 ESP32 LoRa OLED Board V3 Type-C SX1262 + 915MHz LoRa Antenna U.FL IPEX to SMA for Arduino IOT LoraWan Gateway, not Compatible with WiFi LoRa 32 V2
KWD 10.500
DIYmalls Nextion Enhanced 2.4 inch HMI Display Resistive Touch Screen 5V TFT LCD 320x240 for Arduino ESP32 Board (NX3224K024)
KWD 14
-10%
DIYmalls 1.8" inch TFT LCD Display Screen Module SPI Interface ST7735S 128x160 w/SD Card Slot for Arduino U NO Mega-2560
KWD 4.500
DIYmalls 1.44" inch TFT LCD Display Screen Module 3.3V RGB 65K 128x128 4-Wire SPI ST7735S for Arduino Mega-2560 (Pack of 4)
KWD 6
