The Good:
These are simple to install. Stick them in place and plug into the port on the inside and you are good to go. Plugging into the spot for the stock lamp is great so they can be controlled by the machine. They do add more light, and it is better spread out than stock. It definitely helped with viewing through the cameraa.

 Provides Good Lighting, Micro Lidarr Working Fine, Much easier to see what is going on inside the enclosure.

 Big Tip: Comes with 2Pcs light strip, one strip can work with stock light together, install them with the Y conector; the 3 strips need to remove the build in light before installing it, and Installing this lamp leaves the existing lamp inoperable since they both plug into the same socket.

  They improve the cameraa views when room lights are off. Doesnt overload the internal USB port. All the LED lights on each strip work and the long cabling between each strip makes them fit 3 sides of the Bambu enclosures.

 This LED light strip is a great upgrade for 3D printers. It provides bright, even lighting across the print bed to improve accuracy. Easy to install by clipping directly to the frame - no wiring needed. Individual sections allow targeting specific areas. Brightness is adjustable without flickering. Great value for improving print quality, especially on larger builds.

  How to use the lightt kit:
Be gentle and slow pulling off the fabric tape from the upper-left-inside corner, pulling toward the right, as the tape appears to be attached to an electrical ribbon behind the display. Just be careful to plan the wire routing to avoid any potential contact with the printhead. Used black electrical tape to secure the wires. We suggest install it under the front, right side, and rear, better than the right, rear and left sides.