Specification:
Item Type: Tool Setting Gauge
Model: MP11-10-2
Voltage: DC24V
Line Length: Approx. 2 meter / 6.6ft
Output Method: NC (Normally Closed)
Tool Setting Facing: Approx. 10mm / 0.4in
Stroke: Approx. 5mm / 0.2in
Repetitive Accuracy: 0.001mm (Condition: Operating Speed 50-200mm/min)
Contact Life: 3000000 Times
Waterproof Grade: IP67
Contact Force: 1.5N (Installation Status: Vertical)
Contact Material: Tungsten Steel
Surface Treatment: Grinding 4s Mirror
Contact Rating: DC24V 20mA (Maximum) (recommended value 10mA) Resistance Load

How to Use:
Install and use directly.

Package List:
1 Setting Gauge

Note:
1. Try to install it in a place with less iron filings and splashing on the workbench.
2. It must be installed vertically to ensure a flat bottom to avoid excessive accuracy errors.
3. After the wiring is completed, place the tool setting gauge in another place on the tool setting holder, test that the tool setting is normal, and then fix it in the correct position.
4. Please use it correctly within the rated DC24V±10% 20MA (maximum) power range to avoid overloading and burning internal components.
5. The tensile strength of the power and lines is below 20N (2KG), and the bending radius of the metal tube of the power line sheath is R7.
6. If you need to use the blowing function, the outer diameter of the trachea should be 4MM, the inner diameter should be 2.5MM, and the recommended air pressure should be 0.30.6MPA.
7. Please control the diameter of the tool to be less than 20mm
8. Control the cutting speed below 50200mm/min (the speed is related to the mechanical electrical response)