Search

G1/2 ’’ Flow Hall Sensor BSP thread, Food Grade POM 1-30L/Min Flow Meter, Food Grade Flowmeter Counter

KWD 4.500

Brand
SENSTREE
Weight
5 g
1 +

Special Features

  • ☺BSP G1/2 '' Flow Hall Sensor☺Easy to install, heat resistance, pressure resistance, cold resistance.
  • ☺Hall effect☺Flow range:1-30L/min, working voltage range: DC 5-18 V, allow compression: Water pressure 1.75 Mpa below.
  • ☺Wire connector type: SM-3P. Connect to G1/2 inch BSP male thread. Output waveform: square wave, output pulse signal.
  • ☺BSP thread flowmeter can work for Arduino, Raspberry Pi, and Reverse Osmosis Filter.
  • ☺Wide application: It is mainly used in water heater, coffee machine, water purifier, drinking fountain, beverage machine, campus smart card equipment, etc.

Description

POM Food Grade Flow Sensor Specifications:
Frequency: F=7.5 * Q (L / Min) error: ± 2% , current can not exceed 10mA, 450 output pulses/liters. F=onstant * units of flow (L / min) * time (seconds)
Flow range:1-30L/min
Maximum current:10 mA(DC 5V)
Working voltage range: DC 5-18 V
Load capacity: ≤10 mA(DC 5V)
Operating Temp: ≤80℃.
Operating humidity: 35%-90%RH
Allow compression: Water pressure 1.75 Mpa below
Insulation resistance: >100M OHM
Storage Temperature: -25-80℃
Storage humidity: 25%-95%RH
Output Waveform: square wave,output pulse singal.
Cable length:15cm.
It is mainly used in water heater, coffee machine, water purifier, drinking fountain, beverage machine, campus smart card equipment, etc.
Refer to the wiring:
Red wire: VCC(+)
Black wire: GND(-)
Yellow wire: Signal output

Related Items


{"error":"Error","cart_limit":"You have too many items in your cart.","prod_limit":"You cannot add any more of this item"}