PGFUN 6-36V Forward and Reverse Controller for DC Motor

Features:
Universal 6-36V Wide Voltage Module: suits most low-voltage DC motors, such as the most widely used 12V 24V DC motors.
Widely Applications: the relay features forward and reverse function, can be used for any application that requires the ability to reverse motion, like linear actuator, linear guide rail, electric curtain, rolling doors, etc.
Jog Control and Self-locking Mode Adjustable: the module comes with built-in jumper cap, available to adjust the control type according to different application needs.
Easy to Wire: clearly wiring diagram on the shell helps easily connect 3 position switch to achieve basic motor forward and reverse function, it can also achieve complicated applications that may need professional electrician, like adding the limit position, cyclically reciprocating motion, etc.
Warranty: 1 year guarantee and lifetime customer service, any questions, free to contact us.
Overall size: 90 x 58 x 53 mm, PCB board size: 83 x 46 x 20mm.

Q & A (keep updating):
Q1: what's the difference between Jog Control and Self-locking?
A1: Jogging(inching) control: keep pushing the button, and the motor keeps rotating, release the button, and the motor stops working;
Self-locking Control: click the button, and the motor keeps rotating, release the button, and the motor is still working.

Q2. Can this module connect with sensors?
A2: Yes, pls notice that the PCB is NPN-NO wiring, so it needs to connect the NPN-NO sensors.

Q3. How much power of the motor it can drive?
A3: It can drive 80W motor max.

Q4. Can it achieve automatic forward-reverse rotating?
A4: It can not achieve automatic forward-reverse rotating independently, it needs to work with a limit switch or sensors, recommended wiring is connecting a start switch and a limit switch (A-Start point) to K1, and connecting a limit switch (B-Terminal point) to K2, and let the SW1 and SW2 pins be vacant.

Q5. How to connect the sensors?
A5: If it is 2 pins sensor/switch, connect 1 pin (NO) to K1 and 1 pin to com, for 3 pins sensors, connect the VCC pin to DC 6-36V power, connect the signal pin (NPN-NO) to K1/K2/SW1/SW2, and connect the GND pin to com.