ETEPON EM001 oscilloscope kit is an assembled finished machine which can be used directly.
Unlike DIY oscilloscope kit, you don't need to do assembly or soldering work before using, which will avoid some problem caused on soldering or assembling process and save your time
.
. Great Replacement
. ✔ Extended both in width and height
. ✔ Hand-held
. ✔ Added the rotary encoder, makes parameter adjustment more quicker and easier.
. ✔ Easily capture instantaneous wave forms using the Auto/Normal/Single Trigger mode.
. ✔ Display and MCU are mounted on the same board (main board) to avoid using inter-board pin-headers. Analog channel is placed on a separated board which contains most user install parts, so the analog and digital circuits can be better separated.
.
. Specification
. Number of Channel: 1
. Analog Bandwidth: 0 - 200KHz
. Sensitivity: 5mV/Div - 20V/Div
. Sensitivity error: . Resolution: 12-bit
. Input Impedance: 1M ohm
. Maximum Input voltage: 50Vpk
. Coupling: DC, AC, GND
. Trigger Modes: Auto, Normal, Single
. Trigger Types: Rising/falling edge
. Trigger Position: 1/2 of buffer size fixed
. Display: 2.4 inch color TFT LCD with 320 x 240 resolution
. Power Supply: 9V DC (8 - 10V acceptable), NOT INCLUDED
. Dimension: 115mm X 75mm X 22mm
. Weight: 100 gram (not including cables and power supply)
.
. Packing Lists
. 1 * Oscilloscope
. 1 * BNC-clip cable
. 1 * Users Manual
.
. Kindly Note
. It runs on 9V power adapter. The power supply voltage must not exceed 10V. Otherwise it is possible to burn out the machine. 9v dc power supply should be center positive.
.