Jumper cap for use on Hard Drives, Circuit Board, Computer Interface cards, etc.
Model: Standard 2. 54mm/0.1inch pin spacing; Color: Black; Material: Plastic; In the package of: 40pcs x Jumper Caps.
Standard 2.54 mm jumper caps are used for controlling the settings of your internal devices' motherboards. Optimize your system configurations with standard jumper caps.
Jumper cap, Which is an active part, The outer layer is insulated plastic, The inner conductive material can be inserted in the jumper pin above the two jumper pin connected; When the jumper cap is fastened to the two jumper pins, It is on and the current is passing through, Which we call ON. On the contrary, do not buckle the jumper cap, It means is disconnected, Call it OFF.
Please allow 1-3mm error due to manual measurement. Thanks for your understanding.
MECCANIXITY PCB Board Single Sided Printed Circuit Prototyping Boards Plated Through Holes for DIY Soldering Electronic Projects, 130mmx250mm, Pack of 2
KWD 6
TLV3501 High Speed Waveform Comparator Frequency Meter Front Shaping Module 2.7-5VDC Rail to Rail Output Can Directly Drive TTL/CMOS Level Voltage Signal Shaping Period 1Hz-120MHz
KWD 4
Digilent Cmod S7: Breadboardable Spartan-7 FPGA Module
KWD 39
2PCS MV Microvolt Signal Amplifier Voltage Amplifier AD623 AD620 Instrumentation Amplifier Module (AD623)
KWD 6
