Schedule 40 elbow fitting is made of PVC and is corrosion resistant, high strength and has a slip connections. The fitting is installed between two straight pipes to allow a change in direction of flow from 0-25 degrees with a twist of the wrist achieving any degree without pipe bend or tension. The fitting provides superior flow because of its smooth interior finish, which reduces friction and inhibits build up of material. The Haines Multiple Angle Connector is intended to be used for permanent installation for waste/vent and cold water pressure distribution (non-potable) pipes. It has female slip opening for sliding over the end of male unthreaded pipes. All joints to be glued with PVC solvent cement.