Description
1.27inch OLED Display Module
Embedded SSD1351 Driver Chip, SPI Communication
Comes with examples for Raspberry Pi, Arduino, STM32, etc.

Overview
Operating voltage: 3.3V/5V (Please ensure that the power supply voltage and logic voltage are consistent, otherwise it will not work properly)
Support interface: 4-wire SPI, 3-wire SPI
Controller: SSD1351
Resolution: 128(H)RGB x 96(V)
Dimension: 25.708 × 19.28mm
Pixel size: 0.047 × 0.185mm
Display color: 262K color

Pinout
RES---Reset, low active
DC---Data/Command selection (high for data, low for command)
CS---Chip selection, low active
CLK---Clock input
DIN---Data input
GND---Ground
VCC---Power (3.3V / 5V input)

PS: This module only has SPI interface, please pay attention when using it.

OLED and its controller
The built-in driver used by this OLED is SSD1351, which is a 128RGB * 128 Dot Matrix OLED/PLED controller with a 128*128*18bit SRAM as a display buffer
area, which supports two color depths of 262k and 65k. And supports 8bit 8080 parallel, 8bit 6800 parallel, 3wire-SPI and 4wire-SPI and other
communication methods.
This module selects 4wire-SPI and 3wire-SPI as the communication method, which reduces the area of the module and saves the IO resources of the
controller.

Package Content
1.27inch RGB OLED Module x1
GH1.25 7PIN cable x1

FAQ
1.This module only has SPI interface, please pay attention when using it?
The OLED module is used in a 3.3V system by default, but after our 24+ hour aging test, we found that it works fine in a 5V system.

2.How many hours does the OLED module last?
Under normal operating conditions, there are typically 50,000 hours.

Note
Development Resources is provided , please contact us if you have any problem .