This permanent match is a helpful tool for it combines practicability and convenience, which making it popular for hiking or camping gear, also for hunting, traveling and other outdoors activities. HOW TO USE? 1. Rotate counterclockwise to open the lid and add kerosene. 2. Screw the scraper back and wait 2 Min, let the cotton and wick fully absorb the lighter fluid. 3. Holding the scraper at a 45-degree angle with the flint. Push hard and slide downward to ignite. Important: Please Scrape off the black wax on the surface of flint strips for the first time use. The black plating and small contact area are both not good for spark making. When the wick is burned to black and become short, the wick can't absorb enough fluid so it will be difficult to ignite. Please extend or change the wick by the steps as below. 1. Pull the steel scraper out by pliers. 2. Slowly pull the wick out, stop pulling if you think it's long enough. Please directly change the wick if it's too short to wrap the scraper. 3. Put the scraper back to the middle of the wick, and then lightly hammer it back to the pipe. 4. The exposed part of the wick should be at least half of the length of the exposed scraper. Package Includes: 1 x Permanent Match 1 x Accessories User Manual: - Please make sure that a small amount of fuel (lighter fluid or kerosene) should be added before igniting fire. Just Fill the bottle about 23 full of lighter fluid. Be Careful! Never put your finger toward the scraping direction, or else the scraper may hurt your finger.