This is an simple and practical fishing tools,you can easily store your fishing rods and reels before or after fishing,Move your fishing location soon! Bike fishing rod holder can make fishing easier for you, to help raise your fishing efficiency.
How to install
1. Take two R-shaped pipe clamp from the four sizes of R-shaped pipe clamp to fit the diameter of the seat stay and the chain stay, and snap them onto the chain and seat tube 6in from The axle of the rear wheel of the bicycle (The flat side of the R-shaped pipe clamp faces you, the warped side faces in，The screw hole is facing upward,the seat stay usually use 20 mm pipe clamps and chain stay usually use 22 mm pipe clamps)
2. Overlap the bike fishing rod holder screw holes and the upper and lower two pipe clamp screw holes .
3. Connect the two R-shaped clamp screw holes and the bike fishing rod holder screw holes with butterfly bolts.
4. Install the nut，Adjust the installation position，then use the included wrench to tighten the nut and bolt.
5. 2 link fishing rod holder need the cable zip ties need to be locked with a cable zip tie through the hole in the middle of the two rod holders in order to form a triangular fixing with the butterfly bolt.
Size: Height: 10.6”, width: 1.8”, Inlet diameter: 2.2”.
Package Includes:
fishing rod holder with Aluminum fixing pieces and bungee cord are installed.
Butterfly bolt×2
Flange nut×2
"R" shape rubber clamps：
0.7"(18mm) ×1
0.77"(20mm) ×1
0.87"(22mm) ×1
CAUTION:After installing the bicycle rod holder for the first time, please perform a ride test that，If your heel hits the rod holder when you are pedaling, please re-adjust the installation to obtain the best installation angle and position, so as not to affect the riding safety!