Keep the bugs and dirt out of your expensive EVSE with this extra durable mount. Comes with 4 mounting screws. This holster is NOT 3D printed, it is professionally fabricated at a local factory (in Canada) made from 100 percent recovered/recycled ABS plastic that originated in the USA. I am the first and original maker of these open source dummy inlets that many people are now 3D printing. (originally published Feb 24, 2013 on the thingiverse website). I starting with selling 3D Printed units, and since having caught some attention, I have been asked to deliver higher numbers. This unit is based on my popular hooded dummy that can both hold onto your J1772 plug and your coiled cable at the same time. Each pin has it's own hole which will ensure bugs will not create some kind of mess in the space/gap between your plug and the inlet. This also keeps rain, snow and dirt out of your plug. (That square hole on the back/top of the unit is necessary to add the hook/latch. It is much smaller in this injection molded version.) The most important part of your plug (the pins) are still fully protected.