Sensor Wiring Details:

Pin A = Sensor Ground (-)
Pin B = Signal (ouput)
Pin C = 5 V (+)

Be careful when reinstall the MAP Sensor electrical connector. Please check the wiring details.

Direct Replacement for 1994-2000 GM C/K Pickup Truck Suburban Tahoe Yukon 6.5L Diesel (MAP/Turbo Pressure Sensor)

Calibration Data:
20 Kpa = 0.30 V
200 Kpa = 4.80 V

Tech specs:
This sensor reads up to 2 bar, or 15 PSI of boost.
If you are planning to run more than 15 PSI of boost, we recommend the 3 bar MAP sensor.
* Connector not included.

GM-style 2 bar MAP sensor. This sensor is used to determine engine load on forced induction engines.
This sensor is intended to be used on engines producing positive manifold pressure up to 1 bar, or roughly 15psi of boost.

A new seal will be needed. Do not reuse the old seal.

Please always verify part number and vehicle engine type.