Assembled V5 J-Head Hotend Kit 12V 40W with 0.4mm Nozzles+Silicone Sock, 1.75mm Filament Extruder Hot end Compatible with Anycubic i3 Mega Hotend Series for 3D Printer Accessories

Replacement Hotend: This V5 J-Head Hotend Kit is compatible with Anycubic i3 Mega, i3 Mega X, Mega S series 3D printer. Come with a high temperature resistance silicone sleeve, high temperature resistance up to 280 ℃
Premium Material: Hot end kit is equipped with 12V 40W cartridge heater and NTC3950 thermistors. Heat-resistant aluminum heating block, temperature up to 250 ℃, good heat dissipation performance, can maintain good printing results
Hotend Nozzle: Come with high quality brass 0.4 mm nozzle on the hotend for high temperature printing with 1.75 mm filaments PLA / ABS / WOOD / PETG / TPU
Easy to Install: Both of the thermistor and heating rod comes with connector, simply remove the old J-head hotend and replace it with the new J-head, plug the wires into the electronics board, and you're ready to print. Saving you a lot of time
Assembled Hotend Kit: Pre-assembled Teflon tube runs through the pneumatic joint and down to the nozzle, thus the feeding is smooth and clogging is reduced. Please check that the parts have not come loose in transit before installation

Hello,