Description
This Leadshine DM542 is an advanced motor driver controller, it uses the most advanced DSP control algorithm. Compared with other traditional stepper motor drivers, it has less noise, less thermal power and smoother drive process. This driver is absolutely a good choice for you.
Features and Electrical Parameters
Output Peak Current: 1.0-4.2A (3.0 RMS.)
Input Voltage: 20-50VDC (Typical 36VDC).
Logic Signal Current: 7-16mA (Typical 10mA).
Pulse Input Frequency: 0-200kHZ.
Pulse Width: 2.5μS.
Isolation Resistance: 500MΩ.
Input voltage: 20-50VDC.
Anti-Resonance provides optimal torque and nulls mid-range instability.
Motor auto-identification and parameter auto-configuration when power on, offer optimal responses with different motors.
Multiple stepping allows a low resolution step input to produce a higher micro-step output, thus offers smoother motor movement.
15 optional micro-step resolutions including 400, 800, 1600, 3200, 6400, 12800, 25600, 1000, 2000, 4000, 5000, 8000, 10000, 20000, 25000.
Soft-start with no “jump” when powered on.
8 optional peak current including 1.00A, 1.46A, 1.91A, 2.37A, 2.84A, 3.31A, 3.76A, 4.20A.
Pulse input frequency up to 200 KHZ, TTL compatible and optically isolated input.
Automatic idle-current reduction.
Suitable for 2-phase and 4-phase motors.
Support PUL/DIR mode.
Over-voltage and over-current protections
Cooling: Natural cooling or forced cooling
Environment: Avoid dust, oil fog and corrosive gases
Ambient Temperature: 0℃-65℃
Humidity: 40%RH-90%RH
Operating Temperature: -10℃-45℃
Vibration: 10-55HZ / 0.15mm
Storage Temperature: -20℃-65℃