Features:

1.Nowadays, EEPROM chips in many motherboards, routers, set-top boxes, LCD screens, game consoles, etc. use SOP8.

2. Rather than the traditional process of removing the chip and rewriting, you can use this clip to directly hold the chip and rewrite.

3.Please note: Depending on the circuitry around the chip, it may not be possible to insert the chip directly. Please check the location of the chip on your motherboard before purchasing.

4. It prevents damage to the chip and is very efficient.

5.This test clip can be used by connecting with many high power programmers.

6. When connected with a programmer with protection function, it cannot be read at normal voltage. You need to add 3.3V voltage.

7.How to use: While holding the chip, add 3.3V to the pin that hits the 8th pin of the chip.

8. There are two wires for the 3.3V power supply, VCC should be connected to the clip and the other should be connected to ground.

9. Do not force down when pinching to avoid breaking the tip of the clip. Open the clip and pinch it from both sides of the chip.

10.And when removing it, do not pull it out directly. Separate the left and right sides of the clip and then remove them.

CH341A programmer features:
Download support for single-chip series procedures.
Equipped with CH341A chip that can recognize 25 series chips.
The lamp indicates the 24/25 status.
Supports utility expansion via SPI pins.
Support 24 EEPROM and 25 SPI flash 8pin or 16pin chips.

Package include:
2 X CH341A USB programmer;
2 X 8Pin to 8Pin converter;
2 X SOP8 SOIC8 test clip;
4 X 2.54mm 4-pin header;
4 x SOP8 SOP16 to 8Pin converter