Valve With Power-Off Reset Function. Prior To Each Use Or After Extended Periods Of Non-Use, Connect To Power Source For Approximately Two Minutes To Charge The Built-In Capacitor.

Technical Parameters:
◎Actuator Type:ISO5211 Standard Actuator
◎Valve Body Diameter: 2 inch NPT;
◎Valve Body Material: Stainless Steel 304 ;
◎Actuator Material: Engineering Plastics;
◎Sealing Material: FKM and PTFE;
◎Wiring Diagram: CR502-B (Electircal Singal Position Feedback Auto Return When Power Off);
◎Working Voltage: 110-230VAC 50&60Hz;
◎Working Current: ≤1.0 Amps;
◎Working Medium: Fluid, Air;
◎Working Pressure: Max 145 Psi;
◎Switching Time: ≤15 sec.;
◎Life Time: 70000 times (Testing pressure is 0.4MPa, medium is water)
◎Actuator Rotation Angle: 90°;
◎Torque Force: 15 N.m.;
◎Cable Length: 0.5m;
◎Environment Temperature: -15℃ ~ 50℃;
◎Liquide Temperature: 2℃ ~ 90℃;
◎Switch Indicator: YES
◎Manual Override: YES;
◎Protection Class: IP67
Application:
◎HVAC;
◎Water Treatment;
◎Chemical Process;
◎Air Compressor Drainage;
◎Automatic Control System;
◎Solar Hot Water Engineering;
◎Watering Flowers, Regular Humidification;
◎Air Conditioning Automatically Humidifies;
◎Automatic Control Of Small Industrial Equipment;
◎Environmental Protection, Efficient Water-saving;
◎Replace Solenoid Valve (Especially when solenoid valve cannot work reliably);
Manual Override Instructions:
◎In case of anelectric supply failure, it is possible to operate the actuator manually.
◎Power must in off position when start the manual override.
◎Gently putt up the knob about 3mm, then revolve the knob around left and right to control the valve open or close.
◎When the red needle in the indicator pointing to "S", means the valve is closed; When pointing to "O", means the valve is open.
◎After finish the manual override operation, must press down the knob, so that for the normal electric operation.