Dismounting shaft bearing
1. Remove this bearing; 2. Find the suitable extraction ring; 3. Install the pull ring; 4. Connect as shown; 5. Load the screw handle; 6. Nesting adapter; 7. After the set; 8. Connect the removal device; 9. Stable nut with one hand turn the handle clockwise; 10. Disassembly completed
Bearing installation
1. Choose the correct clamp; 2. Alignment; 3. Connected tools; 4. Hold the nut and turn the handle clockwise; 5. Press in; 6. Installed
Demolition of the bearing
1. Demolition bearing bearing; 2. As the picture shows; 3. Device ready; 4. Placed on a square nut; 5. One lock nut with one hand, one hand turning the handle clockwise
Bearing mounting
1. Press bearing into center shaft housing; 2. Find the correct clamp; 3. Hold the nut and turn the handle clockwise; 4. Press in
Shaft installation
1. Find the correct pressure block as shown in the chart; 2. Installing the other half; 3. Hold the nut and turn the handle clockwise
Installation essentials: the center edge of the center axle housing must be framed; the five links are parallel; Wipe off the grease inside the front edge of the five-way installation.