USB2.0 9PIN to 2 9PIN cables
Convert the USB2.0 9PIN interface on the motherboard directly into two 9PIN interfaces
USB2.0 9PIN Female to 2 9PIN Male (Gold Plated)
USB2.0 has 2 groups of USB2.0 signals, one port on each side
This cable is used to connect 2 groups of one side to a group of cables with 2 9PIN headers, so that the 9PIN is output via the native USB signal of the motherboard and not via the chip transmission, the speed is high and the compatibility is good, the transmitted 2 root 9pin line can be used at the same time.
♦Suitable for NZXT water cooling, LED lights, graphics card display, air cooling and other USB control board ports.
Note:
With a unscrewed 9PIN only one port can be used. This cable is suitable for water cooling, LED lights, graphic displays, fans, etc., as these devices only use a set of 9PIN signals and do not use a 9PIN at the same time 2-port signals
It is not recommended to plug the 2 USB 9PINs on the panel of the chassis, as the USB port of the chassis requires the signals from 2 USB ports while using the full signal.