TP4056 battery charging board has protection function, battery can be charged and discharged at the same time

Description:
Input with Type C USB female socket
You can directly use the mobile phone charger as the input to charge the lithium battery
Retain the input voltage wiring soldering points, can be very convenient DIY

Parameters:
Input Voltage: 5V
Charging Cut-off Voltage: 4.2V ±1%
Large Charging Current: 1000mA
Battery Over-discharge Protection Voltage: 2.5V
Battery Overcurrent Protection Current: 3A
Size: 2.6*1.7CM

Usage:
The first time you access the battery, there may be no voltage output between OUT+ and OUT-, then access the 5V voltage to charge a little to activate the protection circuit, the battery is disconnected from B+/B- and then connected again if you also need to charge a little to activate the protection circuit. When using a mobile phone charger as input, note that the charger should be able to output 1A or above, otherwise it may not be able to charge properly
The Type C USB female connector and the +/- pads next to it are the power inputs, connect them to 5V, B+ to the positive terminal of the Li-ion battery, B- to the negative terminal of the Li-ion battery, OUT+ and OUT- to the loads, such as connecting to the positive and negative terminals of the mobile booster board, or other loads
Connect the battery to B+/B-, insert the mobile phone charger into the USB female socket, the red light is on for charging, the blue light is on for full

Package Content:
15 * TP4056 Charging Discharging Module