Attention: Inductive loads need about 3-10 times of rated power to start, e.g. refrigerator, coffee machine, vacuum cleaner. Double check your inverter is sufficient power to start these loads. If the inverter surge power is not enough to start the load, you need to buy a higher power model. Simply it is to say that: Not a 2500W rated power inverter can start all appliances lower than 2500W Always keep you are having sufficient DC power supply if you are using higher power output.(bigger size battery or keep your car engine is ON while running high power loads).
Pure Sine wave inverter 2500W with IP54 waterproof sockets
★Continuous Power: 2500W
★Max Power: 2700W
★Surge power: 5000W
★Output waveform: Pure Sine Wave
★THD: ≤4%
★Efficiency(Full load): 85%
★Input voltage: DC20V (20-30V)
★No load current draw: ★Output voltage: 110-120Vac 60Hz
★With DC 5V 2A rated USB port and wire ON/OFF remote.
★Protections: Overload, low voltage, over voltage, output short, over temperature shut off
★With dual thermal controlled cooling Fans(High speed)
Operation Guide for the Wire Remote control
★To use this wire remote ON/OFF control kit, you MUST turn the manual ON/OFF switch to OFF position. In case you find the inverter cannot start up higher power load as the inverter will bleep in starting or running high power appliance by using with the wire remote, you can just change to use the Manual ON/OFF switch to operate and the bleeping will be off. The remote wire draw about 1VDC for the Input DC voltage which may cause the inverter trigger the low voltage alarming and protection earlier if the battery size too small or the Load AC output power too big. To keep sufficient and continuous using, you better keep your car engine is ON if you are continuously using high power appliance!