use on 14" Band Saws and 24" Scroll Saws.Table Inserts (pack of 2). Material: Aluminum
They fit Delta, Rockwell, some Jet, Ridgid, Grizzly, and other imports.
Make sure your insert recess has the locating pin on the side , not on the rear
IMPORTANT INSTALLATION NOTE:I have sold several hundred of these and occasionally someone will have the problem of it being a bit too large. First make sure the lip of the hole is free from dirt. If a table alignment pin,is not tight or missing,often the blade mounting slot will close up some over time which reduces the insert hole diameter slightly. I tap a flat head screw driver into the blade installation slot a bit to wedge it open. That should spread the insert hole enough for it to fit
Please measure your saw as some Delta & Rockwell 14" bandsaws has slightly smaller holes for the throat plate. If so some slight filing or sanding may be required.
6JE Solid Coupling Insert Fits S-Flex Sure Flex Gear Sleeve Solid Design, 3.75'' OD, 1.875'' Elastomer Length,450 in-LB Torque, 6000 RPM
KWD 7.500
5J Coupling Sleeve Elastomer 5JE Fits S-Flex Sure Flex Gear Sleeve Solid Design, 2.94" OD, 1.56" Elastomer Length, 240 in-lbs Torque
KWD 6
7JE Coupling Sleeve Elastomer Fits S-Flex Sure Flex Gear Sleeve Solid Design, 4.34" OD, 2.19" Elastomer Length, 725 in-lbs Torque
KWD 10
-4%
380452-00 Miter Saw Handle Fits DeWalt Handle Clamshell Set DW704, DW705 (Types 1-5) handle replacement,3660 3680 (Types 1-3) replacement handle
KWD 12
