Front panel controls Installation
InstallationSet your source volume at a position between 6 o'clock and 9 o'clock, and leave it at this setting. Always use the AVA1210 volume control as a master main volume control. It has better electronics, higher signal to noise ratio and is more linear than any source unit volume control available. If engine noise is audible, check the ground connection on all units and in the audio system.
FeaturesVolume control with up to 8 volts RMS of output
Seven band equalizer with 18 dB boost/Cut
Specific bandwidth for each band
Low noise BI-FET op-amp design yields minimum distortion
On-board 30 volt BI-Polar switching power supply
Subwoofer outputs and level controls
Subwoofer frequency selection switch (32Hz/64Hz/128Hz)
Input selector for AUX or CD
Universal half-DIN chassis for ease of installation
Gold plated RCA input/output connectors
20 dB headroom eliminates signal overload
Blue light illumination
SpecificationsFrequency bands: Front channel – 125Hz, 500Hz, 3.5kHz, 12Khz / Rear channel – 50Hz, 600Hz, 6.3kHz
Boost/Cut: +/-18 dB
Signal to noise ratio: 110 dB ref 1 volt input
Frequency response: 1Hz – 15kHz, +/-1 dB
Maximum output voltage: 8 volts RMS
Total harmonic distortion: 0.05%
Input sensitivity: 150mV
Headroom: 20 dB
Input impedance: 10k Ohms
Stereo separation: 82 dB/1kHz
Operating voltage: 11-15 volts negative ground
Output impedance: 50k Ohms
Dimensions: 1” x 7” x 4-9/16” / 27.5mm x 178mm x 115mm