POWER (Power Supply Connector):The connector terminal (+) must be connected to the battery's positive pole with a 4mm² (minimum) wire gauge. The connector terminal (-) must be properly connect to the battery's negative pole with a same wire gauge. The remote terminal must be connected to the Head Unit REMOTE output with a 0.75mm² wire.
INPUT: Inputs of signals to be amplified. Connect these signals to RCA outputs of Head Unit, using good quality shielded cables to avoid noise interference.
LEVEL: It sets the amplifier input sensitivity, which allows an optimal adjustment to the output signals levels of nearly all models of Head Units found in the market
Short-circuit Protection: Shutdown the amplifier when detect a short- circuit or impedance lower than the supported at the output.
Description
1 x Taramps TS400X4 Full Range Amplifier Quantity: 1 Amplifier Number of Channels: 04 Max Power at 13.8 VDC 2 Ohms: 400W (4 x 100W RMS) Max Power at: 13.8 VDC 4 Ohms: 252W (4 x 63W RMS) Bridged at 13.8 VDC 4 Ohms: 400W (2 x 200W RMS) Input Sensitivity: 200mV (Vol=Max) Signal to Noise Ratio: greater than 90dB Frequency Response: (Full Range): 18Hz to 30kHz (-3dB) High Pass Crossover (HPF): 90Hz (-12dB / 8th) Low Pass Crossover (LPF): 90Hz (-12dB / 8th) Input Impedance: 22K Ohms Thermal Protection System and Short Output Minimum Supply Voltage: 8 VDC Maximum Supply Voltage: 16 VDC Standby Power: 0.8 A Maximum Musical Power: at 13.8VDC: 16.5 A Maximum Consumption in Sine Signal: (1kHz) 13.8VDC: 33 A