0.96inch OLED Display Module.Embedded SSD1315 Driver Chip, SPI / I2C Communication.Comes with examples for Raspberry Pi, Arduino, STM32, etc.

Specifications
Operating voltage: 3.3V/5V (IO high-level voltage is as same as the power supply.)
Communication interface: 4-wire SPI / I2C
Screen type: OLED
Control chip: SSD1315
Resolution: 128 × 64 Pixels
Outline dimensions: 26.0mm × 26.0mm
Display size: 21.74mm × 11.18mm
Display colors: Blue/White/Blue and Yellow (1/4 yellow on the top)
Operating temperature: -20°C ~ 70°C
Storage temperature: -30°C ~ 80°C
Viewing angle: > 160°

Control Interface
RES---Reset, low active
DC---Data/Command selection (high for data, low for command)
CS---Chip selection, low active
CLK---Clock input
DIN---Data input
GND---Ground
VCC---Power (3.3V / 5V input)

Package Content
0.96inch OLED Module x1
Jumper cable female-female 7PIN x1

FAQ
How many volts can the OLED module be used in a system?
The OLED module is used in a 3.3V system by default, but after our 24+ hour aging test, we found that it works fine in a 5V system.

How many hours does the OLED module last?
Under normal operating conditions, there are typically 50,000 hours.

OLED module connected to the power supply why does not light?
OLED is no backlight, the display belongs to the self-luminous way. Only connected to VCC and GND, OLED will not light up.
You must use the program control to highlight the OLED.

What do I need to be aware of when using this OLED module?
1. Be careful not to reverse the power connection.
2. Can not display the same screen for a long time, otherwise, it will produce residual images and lead to OLED damage.

Note
Development Resources is provided , please contact us if you have any problem .