Product parameters:
The module supply voltage 2V-10V.
Signal input voltage: 1.8-7V.
Single Operating current: 1.5A, peak current up to 2.5A
low standby current: less than 0.1uA
Product Size: 24.7x 21x5mm/0.97x0.83x0.19in(LxWxH)

Features：
1. Adopt professional driver chip, built-in low on-resistance MOS switch, minimal heat, no heat sink, small size, low power consumption, is ideal for battery powered.
2. dual H-bridge motor drive, can drive two DC motors or a 4-wire two-phase stepper motor at the same time.
3. The dual-circuit working current is 1.5A, and the peak current can reach 2.5A.
4. Built-in overheating protection circuit (TSD) with hysteresis effect, do not be afraid of motor stall and burn out, and it will automatically recover after the temperature drops.
5. Built-in anti-common state conduction circuit, when the input terminal is suspended, the motor will not malfunction.
6. small size, light weight, 0 standby current, it is an ideal choice for your model car.

Precautions:
1. Pay attention to the positive and negative poles of the power supply. The reverse connection of the positive and negative poles of the power supply will definitely cause chip and circuit damage.
2. Output is shorted to ground or output short circuit, and the motor stall, the chip will heat protection, but in the near or exceeding 10V voltage and peak current is greater than 2.5A situation can also cause chip burned.

Package Includes：
5 x Mini L298N DC Motor Drivermodule
1 x 40Pin
1 x 40Pin Female to Male Dupont Cable