Search

Search

BE-180 GPS Module Beidou GPS AntennaTTL Level 38400bps for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller

KWD 8.500
ColorBE-180
All electronics ship with US style plugs. You may need a voltage converter or a plug adapter.
– 1 +

Special Features

  • This BE-880Q GPS Module using the latest 10th generation chip. BE-880 gps module is dual module compass, with and electronic compass IC QMC5883L
  • BE 880Q gps module has flash to save configuration. So you do not need to reset next time when you use it
  • When you use it for Raspberry Pi, there is no driver needed. Here is connection with RPi, red to 3.3v, black to GND, green to TXD white to RXD. The blue (TX) light flashes when power on, indicating there is data output.
  • DIts data Level is TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable.
  • Baud Rate : 4800bps to 921600bps, Default 38400bps. You can set the baud rate you need in this range according to your needs.

Description

Description:
Chip: M10050
Receiver mode: GPS, Galileo, BDS, QZSS and SBAS
Frequency: GPS L1, GLONASS L1, BeiDou B1, SBAS L1, Galileo E1
72 search channel
Baud rate: 4800bps-921600bps, 38400bps by default
Output level: TTL or RS-232, TTL by default
Output agreement: NMEA-0183 or UBX, NMEA-0183 by default
Single: GNSS:1Hz-18Hz
Standard: GNSS:1Hz-10Hz,1Hz by default
Size: 18*18*6.2 mm

Module pin
1.PPS, Sec pulse will output after positioning, pulse period is 1s, high level persists 100 ms, used for system synchronization
2.GND, connect to the ground
3.TX data output of module
4.RX data input of module
5.VCC, 3.0V-5.5V, recommend 5.0V
6.BOOT

Package Includes:
1 X BE-180 GPS module
2 X Cable

Related Items

{"error":"Error","cart_limit":"You have too many items in your cart.","prod_limit":"You cannot add any more of this item"}