All electronics ship with US style plugs.You may need a voltage converter or a plug adapter.
Special Features
The maximum instantaneous current consumption of ESPC2 can reach 400~500mA, so the recommended power supply is 500mA. LDOs such as XC6206 and 7533 cannot be used;
According to the 500mA power supply requirements, it is recommended that the PCB linewidth (including VCC and GND) is not less than 30mil. If the power cord has through holes, it is recommended to use 2~3 through holes to prevent PCB production problems
For better RF performance, refer to the module placement method in the manual. If the product has certification requirements, it is recommended that there are no parallel wires near the PCB antenna, and the download interface should be reserved far from the antenna:
It is recommended to remove the module before downloading the program, otherwise it may cause some unpredictable problems:
If the module cannot start normally and has been rebooted, it is recommended to check the power supply, including the power input, power trajectory width, diameter, and power rail ball
Mister FPGA Metal Housing Kit, 32Mb SDRAM Board with Tutorial, USB Hub V2.1 Io Board Metal Housing Set for Simulates Game Consoles, Computers, and Arcade Boards
KWD 57
Waveshare 10.1inch Capacitive Touch Screen LCD Compatible with Raspberry Pi 5/4B/3B/Zero/Zero W/Zero 2W/Pico/Pico W/Pico WH, Comes with Case and Toughened Glass Cover 1280×800 Resolution HDMI IPS
KWD 52.500
915MHZ ESP32 LoRa Development Board V3 SX1262 ESP32 LoRa V3 with OLED Display Type-C + LoRa Antenna for Arduino LoraWan IOT Internet
KWD 11
Waveshare Starter Kit, Compatible with Raspberry Pi 5, Bundle with Raspberry Pi 5 4GB, 64GB TF Card, Cooler, Case, Cable and so on (8 Items)
KWD 43.500
