Specification:
Item Type: Throttle Cable
Material: PU, Stainless Steel
Applicable Model: Excavator, mixer
Specification: Approx. 2m / 6.6ft
Introduction: The cable accelerator is connected with the accelerator pedal at one end of the cable and the throttle valve at the other end of the cable through the fulcrum and . When the accelerator pedal is pressed, the throttle opens at a corresponding angle. Therefore, the throttle can be controlled more directly and quickly, and the throttle response is faster and more timely.

How to Use:
1. First, put the throttle line through the upper cover of the carburetor, then put the spring on the throttle line, and then extend the throttle line through the throttle hole, pull it out from the slot near it, and wrap it to the bottom, and put the head of the throttle line into the for Mekong at the bottom of the throttle valve.
2. When installing the throttle valve into the carburetor, pay attention to the small slope of the throttle valve facing the idle screw, and the long facing the side with a raised point in the carburetor to the bottom, and then tighten the cover. At this time, the throttle valve can be seen from the throat of the carburetor to the bottom.
3. Open the cover of the plunger, and then pass the throttle wire through the middle of the spring of the plunger cover.
4. Pass the plug hole of accelerator cable through, and then lock and fix it with screws to complete the installation.

PackageList:
1 xThrottle Cable