Product Specification:
**Please Check the Voltage and Connector Size Before Order**
INPUT: 100-240VAC, 50/60Hz
OUTPUT: CC-CV mode, 42V max, 2Amp max.
Case: Fireproof ABS case friendly for environment
Applicable battery types: 36V Lithium (Li-ion) battery packs.
Connectors: 5.5mm Barrel 1-Prong, 8mm Mini 3-Prong, 8mm 1-pin RCA

Compatibility：
42v 2a charger is used for 36v li-ion battery.Compatible with Jetson, Razor, Swagtron, Bird, Gotrax, Segway, Lime, Xiaomi, Minipro, Highboy, ES3, Ninebot, Sisigad, etc.

The indicator light indicates the whole process：
Red light means charging. Green light means battery full charged or disconnected.
After the interface is connected to the scooter, the indicator light changes from green to red.
When the hover board charger completes charging, the indicator light changes from red to green again. At this time, you can disconnect the hoverboard charger

If it does not charge your scooter, there may be one of the following reasons:

1.IF The green light is on when the power is plugged in, but after connecting the scooter, the green light will not turn into red, it is possible that the device is not

successfully connected. Please confirm that the device is fully plugged in.
2.If there was a green light when the power was plugged in. After connecting the scooter, the light went out, it is because the internal short circuit of the scooter, which

causes the charger self-protection function.you'd better check your scooter battery,and replace the battery.
3.The charger is not suitable for your scooter.
4. Due to the limited life of lithium batteries, Your battery is broken.

NOTICE：

√ Don't use when your battery is broken.
√ Monitor the temperature of your battery the first time use this charger.
√ Cut-off the AC when the battery is full charged.
√ Cut off charging immediately if the temperature is too high.
√ It is normal that the charge gets a little bit hot when charging.
√ Don't cover the charger when charging.
√ Keep the charger away from water, fire, wet or hot.
√ Feel free to let us know if you have any questions.