4 slot wall mount battery pack holder. Compatible with Makita 18Vmax Lithium and clone packs
Not just another battery holder. Designed to make your day easier.

Desinged for installation:

Mount with 4 #8 x 3/4" or longer screws on 3.5" x 1" spacing.

Keyholes for screws. Mark holes. Drill pilots, Start screws, slide rack on. Tighten screws. No fumbling while starting screws into wall thru rack holes.
OR Just line em up and drive em in.

Racks are better than loose holders. Pre spaced slots. Pack spacing is set by rack and is just right. Faster install.

Mount racks side by side. Screw holes will be 3.5" apart from rack to rack.

Designed for ease of use:
Pack spacing of 3.5" gives room to hold pack sides during insert and removal.

Latching slots hold battery securely. Mount them in your work van. Empty that bucket of packs to a wall of beauty.

Upside down too. Easy 1 hand drop out. Latch empty packs upside down. Full packs right side up.

Angled slots to present pack and ease handling. Better access to pack latch than flat battery mounts. Relief from squeezing fingers between the wall and pack. Find the latch easily.

Storage cups between packs. Not found with single slot holders. A small but free bonus of this rack design.

Prefer non-latching? Cut away latch bar (using wire cutters) to convert to non-latching. Change is permenant.OR Insert pack part way and don't engage the latch.

MadebyMitchell in Syracuse NY USA. Printed using PLA
Capacities from 2 to 5 packs.
Dimensions: As installed height 44.5mm 1.75", Depth 33.2mm 1.30"
Width:
2slot 166.8mm 6.57"
3slot 243.2mm 10.07"
4slot 332.1mm 13.57"
5slot 433.5mm 17.07"
Available as: 5 slot ASIN: B09Z9WZQL4, 4 slot ASIN: B09Z9X23R7, 3 slot ASIN: B09Z9W987Q, 2 slot ASIN: B09Z9WVQY8