How to Install
1. Open the front cover of the machine(not included), remove the grinding disc, and then loosen the screws(not included) that fix the grinding sheets and take them out.
2. Reinstall the new grinding sheets back to the original grinding sheets position and lock the screws(not included), but please do not lock them first. Then, observe the gap between the inner circle of the grinding sheets and the mounting step, and adjust the gap to ensure uniformity.
3. Concentric with the motor shaft and then tighten the screws(not included).

How to Adjust
1. Put the moving grinding disc back into the grinding chamber, adjust the screw, turn it counterclockwise, then cover the front cover and lock it.

2. Start the motor and tighten the adjusting screw clockwise until the grinding piece rubs a sharp sound. Turn off the switch after the motor idles for two minutes.

3. Open the front cover, take out the product, observe the friction marks of the moving grinding piece and the static grinding piece tooth groove, and touch the grinding piece around the hand. If the friction marks on the grinding piece are evenly distributed, and the heat difference of the grinding piece is not obvious. This means that the grinding plate is installed in balance and can be used without adjustment.

Specification
Material: Vajra Sand
Color: White
Applicable Model: #150 General
Assembly Required: Yes
Mount Type: Grinding Machine
Number of Pieces: 2
Net Weight: 1kg/2.2 lbs

Gross Weight: 0.9kg/1.98 lbs
Product Diameter: 14.6cm/5.75in
Diameter of the Largest Hole: 6.2cm/2.44inch
Product Thickness: 2.1cm/0.83in
Package Size: 15*15*6cm/5.91*5.91*2.36in

Package Included
1 Pair* Sand Milling Sheets