Description:
100% brand new
Name: Switching light group
Material: Nylon+3D printing+PAV
Specifications: Top light+wheel arch light+tail spotlight+single group hub+dual turn command remote control switch
Suitable model: For Axial 1/10 SCX10 III for Jeep CJ-7 RC Car

Installation instructions
1、Use the mirror bracket with the top light bracket (included in the kit when purchasing the car) to replace the factory installed mirror bracket.
2、Use the holes in the top light bracket to install the top light.
3、Introduce the power supply wire of the top light into the inside of the car shell (Note: In order to avoid the damage of the wire due to overturning, it is recommended to stick a layer of adhesive tape or play a little hot melt adhesive for protection).
4、Install the taillight, and introduce the power supply wire from the gap at the end of the car shell to the inside of the car shell.
5、Dismantle the two fixing screws in the red circle on the inside of the car shell.
6、Fix the hub (a total of 5-way synchronous output)
7、Connect all the light plugs to the hub and complete the alignment (eventually there will be 1 road output left for more light expansion), and finally only one plug is connected to the frame.
8、Install and fix the four wheel arch lights
9, unplug the servo from the CH1 port of the receiver.
10, the controller input plug (white, red and black three-wire plug) into the receiver CH1 port, the servo is connected to the controller reserved for the special interface, the hub input plug and the wheel arch lights plug were connected to the controller A, B output port to complete the installation.

Packaging list:
Dual turn command remote control switch * 1 (two channels can be independently controlled without interfering with each other, with a maximum load of 1.5A per channel, output voltage=input voltage)
Top light * 1 (white light, shell made of nylon material)
Tail spotlight * 1 (red light, 3D printed material on the shell, patterns and defects are inevitable, please be informed)
Single group hub * 1 (5 outputs in total, with 1 output remaining after all connections are made, making it easier to expand and connect more lights in the future)
Wheel arch lamp * 1 (4 lamps in total, the main body is made of 3D printing material, and patterns and defects are inevitable. Please be informed)
Several installation parts (screws, nuts, washers, etc.) and consumables
(Note: the car is only for display, the car shell head and tail of a total of 6 lights for the original car comes with, this product does not contain)