WARNING: Your Factory wheel studs may extend past the surface of the wheel spacers. In this case you will need to:
1) Shorten the factory studs
2) Purchase a set of shorter studs and replace them with the factory studs.
3) The back of your wheels need to have the open slots (cavities)(at least 2" width and 1/4" deep) between mounting holes for installation of these spacers.These cavities are NEEDED so that the lug nuts and wheel studs can sit in this pocket. Verify this before purchasing.
Compatible for:
1995-1998 Nissan 240SX (Will NOT fit Base Models)
1987-1996 Nissan 300ZX
2003-2008 Nissan 350Z
2009-2024 Nissan 370Z
2002-2024 Nissan Altima
1995-2024 Nissan Maxima
2003-2024 Nissan Murano
2008-2024 Nissan Rogue
2000-2011 Nissan Sentra (SE-R & SE-R Spec V ONLY)
2012-2024 Nissan Sentra
2003-2012 Infiniti FX35
2003-2008 Infiniti FX45
2009-2013 Infiniti FX50
2003-2008 Infiniti G35
1996-2001 Infiniti I30
2002-2004 Infiniti I35
1993-1997 Infiniti J30
1990-1992 Infiniti M30
2003-2010 Infiniti M45
1990-2006 Infiniti Q45
2013-2024 Infiniti Q60

Important Notes
- It's recommended that buyers take the proper measurements to ensure that by adding the spacer, their wheel/tire won't hit the fender or any other part of the vehicle.
- Buyer's need to measure the length of their vehicle's OEM/Factory wheel studs, to ensure it doesn't extend past the surface of the spacer
- Installation should only be performed by a trained professional.
- Make sure you get 6-8 FULL TURNS of the lug nuts before tightening
- Avoid using an impact wrench; improper usage may cause damage to components
- Check and re-torque all lug nuts after 25-50 miles of driving