Brand New PanaVise Custom InDash Mountfor the Mazda CX-7 Model #: 751271207 The Panavise InDash Custom Mount eliminates exposed holes in vehicle for clean, easy, and nearly invisible phone mount installation. Proudly made in the USA from the highest quality heavy gauge steel, this Panavise Custom Indash Mount has been fitted and produced specifically for your car to provide the utmost convenience and practicality. Complete mounting instructions are included with your purchase and are also available below. Compatible Cars: 2007-2010 Mazda CX-7; Mounting Instructions MOUNTING LOCATION: Right side of Radio TOOLS REQUIRED: Dash Tool, Phillips Screwdriver, 5/16" Wrench HARDWARE INCLUDED: None Step# 01 With dash tool assistance, remove the bezel that surrounds the radio, climate control, and includes the air vent assembly. Starting at the bottom pull to release (2) clips. Continue up to release (2) clips to the lower sides of the radio by inserting a Wide Flat Screwdrive into the side of the bezel at the lower edge of the radio. Push clip in to release and lift out bezel slightly. Repeat on other side. Step# 02 Use dash tool to assist with pulling the last (4) clips out by prying the radio bezel directly towards you releasing (5) more clips. Lift out bezel and set aside. Step# 03 Locate and remove the screw to the lower right side of the radio by the Audio Switch. Place the Part with 36A on it over the screw hole and replace the screw. The InDash by PanaVise Mount should fit squarely on the radio edge. Step# 04 Replace the radio and air vent bezel. Install the top part of the mount onto the bottom piece with the (2) Acorn nuts and the 5/16" wrench. If we don't have it listed please email us.