Suitable for screw air compressor oil separator+oil filter+air filter

All 3 filters (24121212+39329602+88171913). They may be shipped in 2-3 different packages, so please be patient and wait for them to arrive.

Ensure that maintenance personnel are properly trained, competent, and have read UP6 Operation And Maintenance Manual.

1 Run the compressor until warm. Stop the compressor, close the air outlet valve, and switch off the voltage.
2 Depressurise the compressor by unscrewing the filler plug one turn to permit any pressure in the system to escape. Remove the plug after the system is depressurized.
3 Depressurise the air receiver by opening the drain valve.
4 Remove the plug, and drain the oil by opening the drain valve. Close the valve and refit the plug after draining. Deliver the drained oil to the local oil collection service.
5 Remove the oil filter and separator. Clean the seats on the manifold.
6 Oil the gaskets of the new filter and separator and screw them into place. Tighten firmly by hand.
7 Fill the oil separator/tank with oil until the level reaches the middle of the sight glass. Ensure no dirt gets into the system.
8 Refit and tighten the filler plug.
9 Close the drain valve of the air receiver.
10 Run the compressor for a few minutes.
11 Stop the compressor and wait a few minutes to allow the oil to settle.
12 Check the oil level. Add oil if necessary. If the oil level is too low, depressurize the system by unscrewing the filler plug in one turn to permit any pressure in the system to escape. Depressurize the air receiver by opening the drain valve.
13. add oil as necessary. The sight glass should be 3/4 full. Retighten the plug and close the drain valve of the air receiver.
14. Reset the filter service warning.