IMPORTANT INFORMATION
The activator may in some cases cause discoloration of PVC siding, tan granite colors, and some finishes used on wood. Test before using! Final results could take up to 5 days.
Before finishing, wipe all surfaces with denatured alcohol or appropriate prep solvent to remove any activator residue.

APPLICATION
Directions:
- Apply 2P-10 adhesive to one surface and 2P-10 activator to the other surface and assemble.
- 2 to 4 seconds for alignment, 10 seconds to set, and 30 seconds to cure.
- For more alignment time, do not use 2P-10 activator. Assemble the parts with just the adhesive and it will set in 10-20 seconds and cure in 5 minutes.

DISCLAIMER
WARNING: Contains Cyanoacrylate. Bonds skin and eyes in seconds. For professional use only. Refrigerate for long term use Store in a cool place, below 70 Use in accordance with the MSDS Keep away from children Always wear eye protection

On what types of surfaces can I use 2P-10?
2P-10 can be used on any material as long as it is clean and the surface is well prepared. The surface should be clean, with no oil, and slightly etched so the glue can bite more effectively.

Can 2P-10 Adhesive bond wood with plastic?

2p-10 can be used to bond wood and plastic with no problem. Care needs to be used with the Activator though. The Activator can cause certain plastics to discolor. 2P-10 does not need the Activator to work and in most cases where plastic is being glued, we recommend skipping the Activator.

Is using glue on both pieces of wood stronger than only one side?
It only needs to be applied to 1 side; it will wet out both sides as long as you put enough on the 1 side. It can help to do both sides if the wood is very porous, but not necessary.