Interfaces: USB 2.0 type A Male for input; 6 pin Female Socket Header for output;
USB to TTL Converter Chip: FTDI FT232RNL
Breakout board pinout: TXD (orange), RXD (yellow), CTS (brown), RTS (green), VCC (red), GND (black), easy to wire;
The I/O pins of serial to USB adapter operate at 5V logic level (VCC power line output 5V , data signal output 5 Volt);
USB 2.0 UART interface supports Windows 10, 11, 8, 7, 2008, XP , Vista, CE, Mac OS, Linux , Ubuntu 11.10, kernel 3.0.0-19;
Data transfer rates up to 3M baud rate;
Internal EEPROM with users writable area;

6-Foot FT232RL FTDI USB to serial adapter for TTL 5V logic level data communication:
Low-profile USB serial adapter is built with FTDI FT232 chip, VCP driver allow for communication as a virtual COM port and D2XX ‘direct' drivers provide DLL programming interface.

If the driver is not auto installed on your laptop, it can be easily downloaded on the ftdichip website, or you may contact us on the order page).

Clear plastic shell and LED Indicators for Easy Monitoring Rx and Tx lines: No more guesswork! Watch the LED lights flash to confirm connection status and data flow is transferring properly.

Serial to USB adapter consoles into your terminal devices for debugging, boot-loading, downloading, programming, etc. No need for messy jumpers, just plug it in and it shows up in Putty.

Reliable communication between your computer and various embedded devices, for IoT project, developing custom electronics, interfacing legacy peripherals, microcontroller board UART or I/O, FPGA / PLD to USB, serial terminal program and development environment: microprocessor, MCU, PCM, Arduino board, pro mini, Raspberry Pi, esp32 development ESP8266, unbrick router, serial monitor, power amplifier, Ham radio, light cube, Bluetooth module, Serial com cable to change firmware, upgrading , etc.

What's Included
1 x USB to TTL Adapter
1 x Manual