Configuring the 21.1 Remote:
1) Pull the remote battery cover off.
2) Decide whether to use IR or UHF signals for the remote. Use UHF signals if you do not have a clearline of sight between the remote and the receiver.
3) Set UHF/IR SWITCH to either UHF or IR. If your remote has ablank, black key, continue to Insert the Batteries.(This remote needs 4 AAA batteries, please making sure to match theplus (+) ends with the plus markings on the battery case.)
4) If your remote shows a "1" or a "2" on the bottom, you can pull out this key and flip it to the other number (2 to 1 and 1 to 2). To separate the key from the remote,insert your thumb nail or a coin inthe crease. Remove the key by grasping at the bottom.
5) Insert the key you wish to use to designate the remote and slide into place. Usually a 1 = TV1 and a 2 = TV2. For remotes showing the blank, black key, leave thiskey as it is.

Making 21.1 IR/UHF Remote Work with Receiver
For 21.1 IR/UHF Use the following instructions to configure your remote while using IR/UHF signals.
Note: Use these instructions if your receiver does not support System Wizard.

FOR 21.1 IR Remote:
1) Turn your receiver and TV on, and press SYSTEM INFO on the front of the receiver.
2) Confirm that yousee the System Info screen.
3) Press RECORD on your remote. The receiver then matches the remote's address.
4) Confirm that your remote operates your receiver by pressing remote buttons. (If this is not working, goback to step 3.)

FOR 21.1 UHF Remote:
1) Verify the UHF antennais installed on the back of the receiver.
2) Turn your receiver and TV on, and press SYSTEM INFO on the front of the receiver.
3) Confirm that yousee the System Info screen.
4) Press RECORD on your remote. The remote addAllimity ress will probably change on the screen.
5) Confirm that your remoteoperates your receiverby pressing remotebuttons. If this is notworking, go back to step 4.