DescriptionMini ST-LINK/V2 on a small single board, an extreme low cost solution for in-circuit debugger/programmer for STM8 and STM32.
FeaturesOnboard 500mA self-recovery fuse to avoid harming by short circuit
Dual voltage output (3.3V/5V), easy for debugging/programming
Standard USB interface for direct connection to PC
Debugging/Programing performance Debugging : run at full-speed, single-stepped, breakpoints, viewing variables and registers, etc.
Programming : supports FLASH ROM, EEPROM, AFR, etc.
USB2.0 combined with SWIM/SWD interfaces : quick response for debugging & fast speed for programming

Upgradable firmware The firmware is upgradable to support more devices in the future
Automatically upgraded

Supported software ST-LINK Utility v2.0 (or higher ver.)
STVD Version 4.2.1 (or higher ver.)
STVP Version 3.2.3 (or higher ver.)
IAR EWARM Revision v6.20 (or higher ver.)
IAR EWSTM8 Revision v1.30 (or higher ver.)
KEIL RVMDK Revision v4.21 (or higher ver.)
ATOLLIC
TASKING

Supported devices All the STM8 devices with SWIM interface
All the STM32 devices with SWD interface